Great for home, vehicle, trailer, shop or office
Installation
Installation Instructions
Parts Included:
- Stor-A-Hitch™ (1)
- #10 Mounting (2)
Tools Needed:
- 1/8" Drill Bit
- Drill
- Screwdriver
- Level (optional)
Wall/Vehicle Mounting Instructions
- Locate mounting location
- Determine orientation (Vertical or Horizontal**)
- Hold unit in desired position and mark screw hole locations
- Pre-drill the two pilot holes with a 1/8" drill bit
- Line up unit over holes and hold in place
- Thread provided fasteners into place and tighten with screwdriver
- Repeat step #6 for second fastener
Unit is now ready to use.
Tips:
** If mounting in a residential / commercial building ,locate a stud for maximum strength and mount vertically.
** If used for in-vehicle application, insert receiver with ball attached to assure proper clearance.
** For horizontal orientation - ball and/or screw should sit on floor
** For vertical orientation - male end of receiver should sit on floor
** We always suggest to mount Stor-A-Hitch in a stable, rigid location. It is not advised or recommended to mount Stor-A-Hitch to an interior molded plastic trim part on your vehicle. If Stor-A-Hitch is mounted to a molded plastic interior trim part, then additional reinforcement may be needed to prevent that part from being damaged or cracked during installation or use.
Disclaimer: If mounted in a vehicle, note that this is a storage device not a safety device.
For additional information about towing safety, hitch systems, towing packages & driving permits we recommend you review the brochure "Towing a Trailer: Being Equipped for Safety" from the National Highway Traffic Safety Administration (NHTSA).
More Stuff
Visit OUR social pages
Share on YOUR social pages
9801 Fall Creek Rd. #163
Indianapolis, IN 46256
info@storahitch.com
Stor-A-Hitch™